Tool Controller Units

The Tool Controller Shut Off System is supplied in a wall box for “External Control” versions of the Norbar PTM series of tools.  This can give a much greater range of functionality than is possible on the “Internal Control” version of the tool.

Features include:

  • The backlit display shows an accurate reading of the torque applied and the settings for the tool controller.
  • The Tool Controller has 12 sets of limits to control the power tool shut-off. each limit has a target value and upper and lower allowances. When the lower allowance is reached the power tool is shut-off.
  • The limit status is shown as LO/OK/HI on the display and with bright LED’s to show “PASS” or “FAIL”.
  • A serial port is provided for data output to a computer or printer.  Options include sending limit status, time and date.

TOOL CONTROLLER (TTT based)

60244 Shut-off system in wall box
60254 Shut-off system in wall box with printer
*Tool Controllers are supplied without leads.

61127.600 Lead for PTM Series Tool
61126.600 Transducer Lead for PT Series Tool
61128.600 Solenoid Lead for PT Series Tool (for single valve)
*Other lead lengths can be ordered at an additional cost. Both 61126.600 and 61128.600 are required to control a PT Series tool with a tool controller.

TOOL CONTROLLER (T-Box XL based)

60302 Shut-off system in wall box for PTM tools
*Tool Controllers are supplied without leads.

61135.600 Transducer Lead for PTM-EC and Angle Series Tools
61135.1000 Transducer Lead for PTM-EC and Angle Series Tools

For use with the Norbar Tool Controllers:
3 WAY SHUT-OFF VALVE

28930 3 Way Shut-off Valve 7 BAR Maximum Air Pressure
28938 3 Way Shut-Off Valve 10 BAR Maximum Air Pressure
*The models above are a sample of the Controllers that Norbar produce.
Please contact Norbar for your special requirements.

Video Coming Soon!